Rosewill RC208 Bedienungsanleitung PDF herunterladen (Seite 9)

RC200 FAQ

8. Question:

How do boot up the system from HD which is connecting to RC200? How to make RC200 a bootable

controller with system HD?

Answer:

Boot from the hard drive attached to the RC-200 controller card:

If we want to boot the system from the hard drive connected to the RC-200 controller card, the hard

drive must already have Windows OS installed. Before the installation, we have to prepare a floppy disk

to copy from the folder, PCI_IO\Cmd0680\raid from our enclosed CD. Then we connect the hard drive

to RC-200 controller card and start the computer. Before we can load into Windows, we need to press

F3 in the BIOS to get into the RAID setup menu and set the RAID we want. Then we have to install

Windows. During the installation, at the very beginning, press F6 to prompt the system for correct driver

path. Direct the path to floppy driver we made. Finish up the Windows installation then.

After doing above operations, but the computer still can't boot from the hard drive attached the RC-200

card, please set system BIOS to boor from SCSI or RAID as first priority boot device.

On the other side, we suggest that use RC-200 Non-Raid controller for the followings:

(1)We are using only one hard drive.

(2).We are using only for CD Rom, CD Writer, DVD Rom, DVD Writer.

1 2 3 4 5 6 7 8 9 10 11 12 13

Keine Kommentare

Rosewill RC208 Bedienungsanleitung Seite 9